• If your have CLUB EVENTS/RIDE & would like to announce it here,
    Message traxxas-modifier about it :-)

Search results

  1. J

    T135 CRANKSHAFT BALANCED by PRECISION RACING updated!!

    Swap po sa gadget pde txt lng kay jefraider.. dn nya ma open acc. nya .....^_^
  2. J

    T135 STOCK CLUTCH LINING for 1st edition Sniper 2pcs avail.

    ^_^
  3. J

    T135 rubber damper

    ^_^
  4. J

    T135 STOCK CDI

    ^_^
  5. J

    SNIPER,CRYPTON Z, X1 HEAVY DUTY REAR SET

    ^_^
  6. J

    T135 CRANKSHAFT BALANCED by PRECISION RACING updated!!

    ^_^
  7. J

    Sniper racing parts

    some parts there are still in my parts cabinet like: friction plate(2pcs new) CRG racing clutch springs stock brake rotor(from xrm for rear break conversion) bnew rubber damper (2 sets) digital tachometer(clip on the tension wire no wiring needed) MCS 15/55 sprocket set(rare) fr...
  8. J

    swap if you have mio.

    mga sir, I am swapping the following racing parts for a stock mio sporty w/ clean papers. or nouvo classic(single headlight) all for sniper: big disk racing boy front fork stabilizer DT 125 carb tuned for "MONSTER SNIPER" 60mm block w/ piston kit balanced crankshaft by precision(8k pa...
  9. J

    Sniper racing parts

    mga sir, I am swapping the following racing parts for a stock mio sporty w/ clean papers. or nouvo classic(single headlight) all for sniper: big disk racing boy front fork stabilizer DT 125 carb tuned for "MONSTER SNIPER" 60mm block w/ piston kit balanced crankshaft by precision(8k pa balance...
  10. J

    61 mm cylinder block

    Hi bros... I am using this 61mm block from jaime barcial but the only leaks that I got was when I REMOVED the THERMOSTAT..but after installing it back there were no leaks from the cooling system..and I dont have any gasket installed just gasket maker...just sharing my xperience..thanks
  11. J

    How to: SQUISHBAND your engine

    very very nice and brave experiment Sir traxx..just to share my set up about this "squish banding" I am using 61mm block with "NO GASKET" at the top and even the bottom of the block!! yes only threebond gasket maker.. valve clearance is .9 for intake and .15 for the exhaust.. (you cannot go...
  12. J

    TRADE-IN Thread

    mga bro.. balanced crankshaft by PRECISION na nka 1.5 na stroker pin with spacer gasket 5yp part number orig from MALAYSIAN Sniper (pina balance) at lightened flywheel or balancer by E.G.V. (bong velasquez)swap tayo with x1r body kit....
  13. J

    assorted mura parts..

    swing arm sir mgkanu po sa inyo un swing arm?..ptxt n lng po 09334207660..thnks..
  14. J

    change racing camshaft

    when installing racing cams also install racing valve springs and adjust your valve clearance 10 for intake and 16 for exhaust. that is the maximum adjustment based on the manual only found in 3s shops
Top