Recent content by blackfly26

does any of our brothers in Thailand have or know any e-mail address of the customer service of Yamaha Motor Thailand, because the one that is provided in their website which is: yamaha@yamaha-motor.co.th is not a valid e-mail address, i have tried sending e-mails about my inquiry for some...

is it really with 6-speed gears??? if it is i think i gotta go for this one. :D

sir PM mo ko sa price ng fairings mo pati kung ano mga kasama.. at tsaka kung meron ka ding Headlight assembly or kahit lens lang ng headlight. thanks

bro it's Yamaha X1 :D , by the way will this DIY hazard light works if i am using a LED bulb for my signal lights? what type of flasher relay i should use. thanks bro.

for everyday use you can use your stock SP, or iridium SP (cold plug) for racing (hot plug), why??? hot plug for racing because it has more heat to detonate the fuel that will give more power. you can also use hot plug for everyday use as long as you're riding for not so long distances, coz...

I did side gapping my stock SP but not to the extent of 90 degrees, i just side gapped until the middle/center of the electrode, and because i don't have a steady hand and i don't have dremel, kikil what i used is a plain nail file the one that the manicurista uses. :coffee:

at first when they check the temp. of the oil they pointed the temp. meter at the dip stick because there's the only way to check the temp. of the oil without the oil-cooler, and after installing the oil-cooler they check it on the radiator from the right side of the radiator is the oil that is...

here is my yamaha X1.

I read a post from the other barrio, according to him that BV is best suited for 59mm & above bore size, below 59mm bore, stock head with long duration cams is good to go. *long duration is the degree of the cams??? anyone can enlighten me please. thanks

ok thanks bro. PiZZNeT i'll check on it once i get back to the Philippines.

Hi! sir Jim Legaspi, can you share me also you contacts in Zamboanga??? can you pm me your e-mail add, because i can't call you coz i'm here outside the philippines, thanks a lot bro.

Up for this question, if i may add, how about the camshaft what stage would be best? i've seen a BV cylinder head 27mm/23mm stock CH of Yamaha X1 just modified by LHK, i think...

mepanousis - kindly go to motomalaya.net, i think they found it there.

thanks everyone for sharing all your electrical know-how(knowledge), thon, @Agent Mike, Sidro, @NOTORIUS BOMB and others.

Good day TS PiZZNeT, can this DIY TUT work on yamaha X1, coz you have only mentioned nouvo & mio other than sniper. thanks & nice thread. i hit the like button already even if i haven't tried it on my mc.