I don't think CDI of T135 had an micro-processor in it with the price in Vietnam is 550,000 VND (equal 50USD) !!
I think the pink wire will increase the bias for inverter circuit when it connect to mass and then the high tension for spark plug increase also. Yamaha connect the pink wire to mass...
Of coz that I done. And the result : I must change the sproket (front and rear) to 15/34 vs 15/39 (original).
1 = 60km/h
2 = 90km/h
3 = 135km/h
4 = ??? the road is not enough to test speed :cry:
Hi guys,
You can see the wiring diagram of T135 that modifier upload and you can try something:
1/ bypass the pink wire to mass (but cut it out from 2nd gear position)
2/ Don't use the Y and L wire of TPS to CDI (take away from CDI)
And tell me what do you feel after you make 2 steps above...
Maybe, but I am considering about the TPS and thermo sensor . What are their function participating in CDI ?
I think they are present in wiring diagram with the protect engine overload at too high of beat and heat.
If I remove the TPS out of function on wiring diagram, what 's matter ? Better...
I had tested all of these options and I found that the 3rd made the engine work with maximum power. So you can change the sproket (front and rear) to use that power.
I wonder that TPS is only protect engine overheat, doesn't it ?
Or TPS participate with excite coil to change the angle of early-ignition depends of speed of engine ? :?: