Help! Alarm Installation

[YY]

Hi guys, I got a Steelmate 986F two-ways alarm intending to DIY it myself but i got some problem understanding the Wiring Diagram.

Where the 'Black' Ground Wire should place it?
Where the 'Grey' Ignition off and 'Blue' Ignition on wire should go if my sparks RX135 does'nt have E-start itself? Should i just ignore the 2-Wire or?

Hope you guys can help mi out.

 

[goff_d_p]

well ground wire sould be placed anywhere there is a bolt attached to the frame. like where a coil bolt is or as for the ignition wire, look at the ignition key lock. look at the wires there, see which ones are there, with my bike it was just plug and play, justs connects via plug caps already there for the bike. the only extra i had to look for the wth right wire to put the e-starte from the remote. but you don't have e-starte. the ignition wires should have a plug, you need to check. you might need an electrical tester to see what has power and what dosn't

hope it helps