• If your have CLUB EVENTS/RIDE & would like to announce it here,
    Message traxxas-modifier about it :-)

Problem with my fuel guage

goff_d_p

Super Veteran
...Ok guys, i got a small problem, I need to know if anyone has had a similar problem. My fuel gauge is stuck at full. Now i have checked all the wiring and i even changed the gauge, and it's still doing the same thing. what i want to know is, has anyone ever taken out the float and can it get stuck? what do i need to do in detail to fix this problem??
 

chat_master08

Super Veteran
same problem... and i also changed a new float for the gas tank... same thing it doesn't work... but i've not yet checked the wirings. i'll try to check the wirings and try to make it work.
 

traxxas-modifier

Super LOLO
Staff member
bro i experienced that too.

First i check the FLOAT.
i removed it from the tank
and try to move it up and down if it will change the fuel gauge level.

i also use Multitester in Ohms range to check if theres a change in ohmeter
the float is working fine.

So i opened up the FUEL GAUGE METER
and there i found out that the Big Resistor (as big as medicinal capsule)
which is soldered
to the meter has loose/disconnected.

its the culprit, so i just resolder it with soldering gun
and there it WORKS!!!!

fuel meter is now ok

:)
 

goff_d_p

Super Veteran
but i have a spare fuel gauge in another meter panel, for replacement parts when my speedo spring broke. and it still does the same thing with the spare.
 

goff_d_p

Super Veteran
"First i check the FLOAT.
i removed it from the tank
and try to move it up and down if it will change the fuel gauge level.
"

I tried this one, and it didn't move. I haven't taken off the front panel yet to check the resisters yet. what should the ohms meter read at for that test, and which wires do i check, all three? or black for ground and green for the "e" of the tank?

just so happens that my new soldering gun just died. I miss the states, where you can buy quality and not SH*T!
 

traxxas-modifier

Super LOLO
Staff member
@goff

if you have spare meter panel there and still it doesnt work
then your fuel float level might be the problem.

there are 3 wires, just use your multitester to check if it ohms changes when moving it. sorry forgot which specific wire, but you can try all wire combinations.
 

goff_d_p

Super Veteran
the wire plug coming out of the fuel tank float is only two. but on the gauge there three. on the float it's black and green, which is on the back of the gauge would be at the(green wire) "E" side. and the (brown wire ) "F"location on the back of the panel goes into a wrapped set of wires that leads to some where that i haven't found.
 

goff_d_p

Super Veteran
i found out what the problem was, the needle was too loose on the pin to the gauge. hehehe my error.
 
Top