• If your have CLUB EVENTS/RIDE & would like to announce it here,
    Message traxxas-modifier about it :-)

TOPSPEED of your T135??

john_carlo

Super Veteran
pls. read da features of uma racing digital speedometer.. it's already recorded so it is in neutral.. it's not accurate.. sniper can't reach 15k rpm.. :D
even in a neutral position stock cant go to 15k rpm but in modified it can
haha, 15k in neutral.. ang laki ng letter "N" na green, sa akin naman nung binalik ko sa stock settings, 120kph nalang cia, my backride o wala aabot pa rin 120 on 15-40. matagal nga lang, d gaya ng Honda CRF 250 na mataas sa height ko hehe, ang 120 KPH parang 10 sec lang ata, tested ko na nung nakihiram ako sa friend kong miner dito sa ComVal, ang lakas talaga arangkada//..
the speedo rpm sensor is not in the right wire.. if you are looking for top speed record of uma meter when you switch it on the key maybe the ts is in neutral state, the record shows in the meter lcd is in 5th gear when the record was made...

like this when is switch the key my snipey is in neutral but the record was taken max in 3rd gear
 
Last edited:
UMA Digital Meter has two calibration for the tachometer. If it is set to "High Act", it reads 15K RPM even only @ 8K RPM. setting it to "Low Act" gives you accurate results. look at my Avatar. That is the Max RPM i reached.
 

ESOJ de GUZMAN JR

Super Veteran
hahaha.. if u have this.. don nyo malalaman kng paano lumabas ang 15krpm.. upto 9k rpm lng po. pro record data lng nya yan kya maximum 15k rpm kc nka high account ung pinili ko. sir francisco.. back-up nga jan. hahahaha..
 

ESOJ de GUZMAN JR

Super Veteran
UMA Digital Meter has two calibration for the tachometer. If it is set to "High Act", it reads 15K RPM even only @ 8K RPM. setting it to "Low Act" gives you accurate results. look at my Avatar. That is the Max RPM i reached.
cge sir. try ko maya ung low-account.. tire circumference ko 105%. naattain ko speed 118kph. nsa 8.5k rpm. naubusan ako ng daan kya bitin. hahaha.. nasasabi nla yan kc wla cla nyan. wahahahaha.. ang kinaganda ng uma digital meter.. nka indicate rn dto kng nagchacharge sya. my idle charge is 13.1-13.5volts. when its running 14.1-15volts. nka indicate rn dto ang temperature ng makina. kinabit ko na ung temp sensor ko sir. kw sir francis?
 
LOL. i did a hard reset on my UMA since it is also have recorded 15K RPM since the default setting is high Act. I didn't install the temperature sensor since it would be take time. :)
 

ESOJ de GUZMAN JR

Super Veteran
LOL. i did a hard reset on my UMA since it is also have recorded 15K RPM since the default setting is high Act. I didn't install the temperature sensor since it would be take time. :)
just tried the lo-account. the problem is. when the engine is in idle position. the rpm won't work. am i right sir francisco.unless you hit the gas and thats only the time the rpm will move.. not like hi-account. you can see the exact rpm even in idle position.. just to record the max speed. choose lo-account. but short ride. city ride.. its good to use hi-account.
 
lo-acct - the copper wire is wrapped around the igintion cable (After the ignition coil and before the Spark Plug plug) and it is working fine on me (Tach moves smoothly like the tach of a car) i am getting very accurate reading on idle, mid and high RPM) and limits to near to 9K RPM on stock CDI more or less around 8800-8900 RPM.

High-acct - paralleled connection to the ignition coil. - i haven't used it yet. :)
 

ESOJ de GUZMAN JR

Super Veteran
ok.. i connect the rpm wire to the cdi white wire.. and i dont follow the instruction the uma racing have. and its works fine on me. i record my max speed at 9k rpm.
 

snipersolem

Veteran
150 kph (300 meters)


Specs: 62 mm block,lighten piston, stage2cams, 28mm keihin stock head (pnp), racing clutchspring, racing valvespring, racing cdi brt hyperband,sp g power, 9 power, yy pang longy big elbow,
 

snipersolem

Veteran
stock gear stock pin.stock sprocket 15x39, mags big tire 70x90 f, 90x 80r.big disk.nxt we will try 400 m rimset slim tire friendly gauge with my friends raider 180 cc 68 mm block and some tweaks.
 

mac kevin

Super Veteran
150 kph (300 meters)


Specs: 62 mm block,lighten piston, stage2cams, 28mm keihin stock head (pnp), racing clutchspring, racing valvespring, racing cdi brt hyperband,sp g power, 9 power, yy pang longy big elbow,

t=distance/speed

150 km/hr=41.6667 m/s

300m/41.6667= 7.2 sec in 300m (time traveled in 300m)

in 400m: ur time is

400m/41.6667= 9.6 sec in 300m (time traveled in 400m WITH 150kph)

ur a drag KING...
 

snipersolem

Veteran
t=distance/speed

150 km/hr=41.6667 m/s

300m/41.6667= 7.2 sec in 300m (time traveled in 300m)
hinete
in 400m: ur time is

400m/41.6667= 9.6 sec in 300m (time traveled in 300m)

ur a drag KING...
even me..i' m amaze! cant believe.for that settings.how much more the others..with big head racing gear trany etc.but when my
 

snipersolem

Veteran
after he reached 150 kph.problem occured..white smoke emited through muffler.whenwe check the muffler smells like plastick not gas or oil.we saw wet on canister and we found out coolant cause its color green.also the oil and coolant mix together.
 
Top