• If your have CLUB EVENTS/RIDE & would like to announce it here,
    Message traxxas-modifier about it :-)

200cc - Which Would You Choose

HKholic

Member
If you were to build a 200cc monster motor, which would you choose? X1R 65mm block or 3.5mm jack crank with 62mm block. ;)
 

macoolet

Super Veteran
Longer stroke mean longer leg. Same meaning. What happen if u have longer leg? You run one step, and the short leg have to run two step :p That the advantage.. So long stroke = More power and more torque but Short stroke = higher RPM. (Accidentally read that on some book..) :p
why just choose one when you can get them both...you can't compare it to a leg...longer stroke with stroker pin is a different thing..you'll be surprise with the result if you have them and not by just reading them ;)
 

HKholic

Member
.5mm offset difference in crank pin location. One is balanced and one is not. Example..........you upgrade to a 60mm piston, the stock crank would then be "balanced" to the heavier piston to reduce vibration/wear and maximize performance. Of course same can be done to stock piston as well.
 

mj viloria

Super Veteran
.5mm offset difference in crank pin location. One is balanced and one is not. Example..........you upgrade to a 60mm piston, the stock crank would then be "balanced" to the heavier piston to reduce vibration/wear and maximize performance. Of course same can be done to stock piston as well.
sir so its still depends on where it was balanced..what if example a balanced crank in a 60mm piston is wore by a stock bore..what could be the difference?

**sorry for the bad english bro
 
Top