• If your have CLUB EVENTS/RIDE & would like to announce it here,
    Message traxxas-modifier about it :-)

Davao Sniper's Guild (DSG) aka TEAM HOTELGS

kayode

Super Moderator
Staff member
the who naman ang DSG member na parati ask about mamaw mods? hehehehe..

clue...


mahilig... sobra...
 

skuter

Super Veteran
@sniping area
hahahaha nabuang naka ana ha!hahaha

@kayode
murag kaila ko ana, ga eyeglass na siya noh? :lol:
 

kayode

Super Moderator
Staff member
si opaw ginapanindigan na jud ang team hotlegs...


@skuter

ehhhhhkkk!! mali! haha! sa naka eyeglasses gapangutana! haha!
 

skuter

Super Veteran
kayode said:
si opaw ginapanindigan na jud ang team hotlegs...


@skuter

ehhhhhkkk!! mali! haha! sa naka eyeglasses gapangutana! haha!
nabuang jud na ug hubo2x.hahaha

hmmm, liboga oi. hahaha lol
 

acidrain

Super Veteran
kayode said:
si opaw ginapanindigan na jud ang team hotlegs...


@skuter

ehhhhhkkk!! mali! haha! sa naka eyeglasses gapangutana! haha!
@kayode

paps tuwang tuwa ako sa avatar mo ha, ang kulit :lol: :lol:
 

kayode

Super Moderator
Staff member
acidrain said:
@kayode

paps tuwang tuwa ako sa avatar mo ha, ang kulit :lol: :lol:


angkol napansin ang kamanyakan? hahaha!

shembot shembot!



@next clue....

red ang motor.... un na! :D
 

skuter

Super Veteran
baligya nako ni.... 62,000 lang, palita na ninyo.haha

13k plus ang mileage. di na siya ana ka limpyo karon kay abog na kaayo.hahaha





 

sniping_area

Super Veteran
grabe na ang isa ka forum lalis na sila sa modify..

kita dwe lecture ta....

LESSON 1



Multi Valve Engines - Most engines use one intake, and one exhaust valve per cylinder, but and increasing number are using four valves per cylinder. Two intake, and two exhaust. Remember, the larger the valves, the more mixture will flow through them, but they are also heavier, and so the engine will not rev as high without the valves floating. Sure you could put heavy duty springs on at the expense of cam and lifter wear, and go broke paying the warranty bills. A better solution is to make the valves smaller, but make more of them, so valve area is greater than before, but the valves are lighter, so the engine rev's higher.
Yamaha even makes an engine with five valves per cylinder. (FZ 750) Three intake, and two exhaust.



The Hemispherical (Hemi) head
 

sniping_area

Super Veteran
LESSON 2

High Performance
Some engines use double valve springs where a smaller diameter spring is inside the outer one.
Other engines even use triple valve springs. Don't forget that the valve spring not only closes the valve, but also pushes all the other parts such as the retainer, rocker arm, pushrod, and lifter, back against the cam; so increasing valve spring tension increases camshaft and lifter wear dramatically.
you might assemble an engine with heavy duty, super high tension valve springs, but don't expect the cam and lifters to last very long. Since you probably don't mind re-building an engine between racing seasons, this is probably acceptable, but a manufacturer could not offer a warranty on a bike with an engine that needed to have its' cam and lifters replaced every year. He'd go broke.
Rather than increasing valve spring tension, the same result of HIGH ENGINE RPM can be obtained by decreasing the weight of the valve train. The springs have less work to do because the valve train has less inertia.
 

sniping_area

Super Veteran
VALVE TRAIN

CHOOO CHOOO CHOOO


Valvetrain is an all-encompassing term used to describe the mechanisms and parts which control the operation of the valves.
 

sniping_area

Super Veteran
Titanium, or Aluminum Retainers - Titanium is very expensive, and aluminum doesn't handle fatigue very well. If money is no object, or the engine is going to be torn down, and checked frequently, then maybe this is the way to go.
 
Top