• If your have CLUB EVENTS/RIDE & would like to announce it here,
    Message traxxas-modifier about it :-)

Genuine Stock vs Genuine Racing (technical)

charge

Veteran
Today I finally get the figures out for our stock camshaft and Yamaha Genuine Racing camshaft (measured while turning the crankshaft by a mechanic)


Here's the stock figure:

IN duration: 225 degree
EX duration: 275 degree

IN opens 15 degree before TDC.
IN closes 30 degree after BDC.

EX opens 80 degree before BDC.
EX closes 15 degree after TDC.

Tapette setting: IN 10, EX 12.


Here's the yamaha race cam figure:

IN duration: 335 degree
EX duration: 315 degree

IN opens 75 degree before TDC
IN closes 80 degree after BDC

EX opens 80 degree before BDC.
EX closes 30 degree after TDC.

Tapette setting: IN 25, EX 20.


Well, I forgot to ask the mechanic to help me measure the amount of lift at the lobe center.

No wonder last time I always get a sudden power drop at mid range rpm when using the Yamaha Genuine Race Cam. GOSHH it is just too extreme for street use.

However, this racing cam is a good pair with a long stroke 240cc prototype engine that we are experiment on.

If you have any suggestions, please let me know how to improve the camshaft design. :)
 

charge

Veteran
Yes, I am trying to. I dont like high cam and there is no low-cam in Malaysia. So thinking to build one for myself.
 

stroker

Veteran
charge said:
Yes, I am trying to. I dont like high cam and there is no low-cam in Malaysia. So thinking to build one for myself.
What's a low cam? :shock: :shock: Why would you prefer a low cam to a high cam?
 

charge

Veteran
stroker said:
What's a low cam? :shock: :shock: Why would you prefer a low cam to a high cam?
I dont want to lose too much low rpm power since my bike will be used on daily basis.

Most of the cams available at my place has no response below 6000rpm. I am thinking of sacrificing a bit at the low end and increase the power from 7000rpm onwards. I am very satisfied with the midrange power from the stock engine.

The stock cam exhaust lobe seems good, but the intake lobe seems to have a short duration.

I plan to increase the duration and lift slightly, as well as increasing the valve overlapping from 30 degree to 40 degree (-20 deg BTDC for IN and 20 deg ATDC for OUT).

may I know your suggestion?
 

phl6684

Moderator
Staff member
did anybody try FAITO racing cam???the mech at my place said that the cam is just plug and play..no need to make valve hole at the piston deeper..(dont know what it call)..hahaha
 

charge

Veteran
At the moment, stock camshaft best match with stock block. None of the racing cam is good, they are mostly designed for big blocks like 60mm
 

Emmanuel

New Member
Hello,

Here's a bit of info some of you may not have been aware of. We are increasingly going into making shift boots for trucks, besides regular vehicles. I know some of us consider our trucks to be beaters for hauling stuff and ourselves around without worrying to much about what it looks like inside, but if you have a truck that you care about, why not come to us to spice up it a little? Here's a sample of an X-terra 00 through 04:
 
Top