• If your have CLUB EVENTS/RIDE & would like to announce it here,
    Message traxxas-modifier about it :-)

[Help] Dont know whats the problem in my t135

tarbashjr

New Member
its all started when my brother borrowed my bike. first hindi na sya ma-start using push starter. then 2 days after, hindi na gumana HID ko. nag kukurap lang pag hi rev. afterwards, bigla nalang namamatay ang makina when in neutral. then, all lights are gone. i found out na sira na fuse. i tried to start the engine using kick, but i failed. although nagawa ko na sya dati nung first nasira yung fuse ko pero nag start naman after 1 kick. then i replaced my fuse and afterwards, the lights are ok. pero pag nagsisignal light ako, bigla namamatay yung engine. hindi ko mastart ang motor pag nakaswitch-on yung ilaw. and a red light comes out in left side of neutral light in dashboard bago mamatay yung engine. hindi ko na sya ma-start using kick. push start button and my HID not still not working. afterwards i found out that my battery is weak and wasted (GS Battery). and i replaced my battery. i borrowed some battery to my friend and i surprised that it started in 1 kick. i think it because his battery had charged already. then after a few minutes, the problem still exist. my RPM goes lower ang makes my engine off again. then i start it gain using kick, and nag start naman. but when i using my signal light, namamatay parin. so i decided to clear my wirings. removed all alarms wiring, HID wirings. removed all lights. but the problem still exist. my battery goes lower and lower. i can start my engine using battery with charge but i have to maintain my RPM to 2k. because the engine will off if i let my throttle down. i asked my friend about this. and he told me that he think the problem is my rectifier. And he told me dont use my bike if my rectifier is dead because it will make trouble in my CDI. it's that true? but, how to troubleshoot my problems or my rectifier? i afraid if i buy rectifier and thats not the problem in the end. mga master, can you help me about this? i made it in a full details para magets nyo po.


sorry for my bad english and taglish words. nosebleed na po ako nyan.

thanks in advance
 

mingomz

Super Veteran
Have you tried to change CDI? That is EXACTLY what happened to me, after I had HID installed from a bad motorcycle shop J****... I replaced the battery fuse, battery and CDI.. Thanks
 

tarbashjr

New Member
hmm, 2 possible problems.. how to troubleshoot that problem? i have no friends here have a bike like mine. i want to test my CDI too. i have a friend have Mio Sports. is miosport CDI the same in sniper CDI?

update:
My bike can starts when my battery is full.
 

dion frio

New Member
TS if you don't know how to check the stator if it's ok or not. maybe you can bring your mc with good mechanic...
coz if you want to diy that problem you need to use tester if the output of secondary of stator is ok.
secondary of stator goes to your rectifier. then the rectifier charge your battery.. isolation will solve your electrical problem..hth

ride safe
 

tarbashjr

New Member
i go to the nearest mechanic i know. he told me that the problem is in my rectifier. no tester used. he just start my bike then touch my rectifier, after a couple of rev, he told me that my rectifier is not heating up. cold like dead. that's the way he troubleshoot my rectifier. he doesn't check the stator. is he right? but i need a comment here before buying rectifier.

sorry for my bad english.
 

tino

Veteran
PALITAN MO RECTIFIER ADD MO NRIN PLITAN UNG SPARK PLUG.....ALAM MO BA KNG BKIT HINIPO LNG NG MEKANIKO MO UNG RECTIFIER NUNG PINAANDAR UNG MAKNA....KURYENTE ANG DUMADAAN DUN AT NATURAL KNG MY VOLTAGE OUTPUT UN SYEMPRE DPAT UMINIT,EH NUNG PAGHIPO NYA MALAMIG N BANGKAY N PALA EDI UN N NGA........PROBLEM SOLVE
 

_superblue_

New Member
good day...
same thing happened to my sniper sir... i lost a lot of money because of wrong recommendations... battery, wiring, rectifier,,, etc...
my advice,,, go to a mechanic that you think really knows about electrical problems...
tell him to check your stator coil... 'coz when my mechanic replaced my bikes stator,,, that's the end of my problem...
thank... ride safe...:)
 

_superblue_

New Member
yep... 2.9k tres hermanas... if you order via yamaha 3s shop, it'll cost you 3.7k plus you will have to wait for a month 'coz they don't have stocks... or you can go to a motorcycle shop near your place... they might have a spare stator coil from other bikes they repaired... like moonraker said, go for the original stator,,, not replacement...
 

Sidro

Super Veteran
@TS: simple (DIY) test on your charging system, before buying needed parts.

1. You must have a multimeter (tester) either analog or digital. (assume you know how to use this meters, if not bring it to a trusted mechanic who knows about electrical/electronics for our MC. Do note: good mech dont just give conclusion by just listening on your problems, they do some tests before giving some conclusions) "wala pang haka-hakang naging totoo agad unless napatunayan nila":D.

Assuming you know how to use these meters:

1. Start you MC (kick/e start).
2. Remove connection on battery the red or positive wire (+) on a hanging position. NOTE 1:Do take some precautionary measure on this red positive wire not to touch any metal on your MC, cause this will cause short circuit.
3. Get you're meter set it to DC read out, connect the red(positive probe) tip of the tester to the red wire (hanged) and the black (negative/common probe) tip to the black or negative terminal of the battery. It must read about 14.5(specs is 14.1-14.9), just take note of the tolerance. If not in specs, this will confirm that your regulator/rectifier is defective. If with in specs proceed below.
4. Set your meter to AC read out, Look for the connecting terminal block for the magneto with 3 terminal wires colors W-whit, Y/R-yellow/red and B-black. Do not disconect this connecting terminal. Just insert the 2 probe of the meter on the back of this connecting terminal in which you can see the wires, insert on the color(s) white and yellow/red. It must read 14v, if not? you have problem with the AC magneto. If yes, you have other problems.
-- this is only my suggestion on how I understood about the electrical system of our MC's based on our electrical diagram and spec sheets. Feel free to comment(s) if I missed something or I have some wrong point/input(s).

Some questions pafs(TS):

1. Do you use LED(s) for your tail/stop light, park light, panel/indicator lights?
 

tarbashjr

New Member
thanks sidro for that usefull DIY test. back to your question. yes, almost all my light are in LED. and im using HID too.
 

Sidro

Super Veteran
thanks sidro for that usefull DIY test. back to your question. yes, almost all my light are in LED. and im using HID too.
Hhhmm, so in this case you can check this LEDZ. Like if you use multi ledz for your stop/tail light, check if there is a single or multiple busted led in this group(stop/tail light) if has, replace it with a new 1. You can do this checking also for your Led park light. This was experience by jeff(the_one), his battery keep on heating up if he turns on the auxillary lights, until the battery give up and replaced it with a new 1 but still experiencing the same problem.
I assumed your auxillary lights such as stop/tail light, park light and panel indicator lights are directly connected to battery?..
 

skwitchidrew

New Member
i have the same problem mga sir., and its been 2 wiks d p din gawa mototr ko., napaltan ko n ang stator and bago n din rectifier ko..... advice sir badly needed...
tnx
 

tarbashjr

New Member
sorry for late reply. primary stator yung problem. my friend suggested me his mechanic that can rewind stator. it is safe to rewind my stator?
 

skwitchidrew

New Member
actually sir nadoblehan ako ng gastos
pina rewind ko stator ko 850 ngastos ko., tpos sbi skin ng mekaniko ko ng yamaha di daw maganda ang rewind di din magtatatagal., ala p isa araw sira n uli stator ko., bumili n ako ng bago sa yamaha ng stator., if i wer u., bili k na lng ng bgo., para sigurado., at dun k bibili sa yamaha mismo order kna lng
 

Sidro

Super Veteran
sorry for late reply. primary stator yung problem. my friend suggested me his mechanic that can rewind stator. it is safe to rewind my stator?
depends on the way they rewind the stator. quality of magnet wire used, process on rewinding used (a. copy number of turns of stock stator or b. re looped windings for power starting purposes, etc) .
 
Top