goff_d_p said:
turn the screw all the way clock wise till it stops. mark it's location on side. they just for shits and gigels just turn it 2 rotations, you have the distance of the 1 5/8's turn from factory to 2 1/8ths turn to play with. just remember the more turns you have the more lean the feul is in mix, i think??
the more turns you have (counter clockwise) means richer mix.
less turns (clockwise) means lean.
do not go
LESS THAN 1-5/8 turns as it will give lean (lack of fuel) which will make your sparkplug hotter.
khai2717 said:
hey i did get the right screw rite?
down there. there r 2 screws, the air screw is the 1 on the left right? the 1 on the right is further in right? wats that screw for by the way? the on right..
as rooster said, LEFT side is the Pilot Air screw also called Air Fuel screw
the right side is the IDLE SPEED screw
goff_d_p said:
all i know is after i did the 2 1/8 turn and rode a wile, my plug had black burn on the metel part. but the procalin and the tip was all ok?
i think its ok for the outside metal to be black.
the important to look is the Center node or the tip of the spark plug.
khai2717 said:
hey everyone..
i just realised sumting.. is it possible that i accidentally turned the wrong screw thus causing the vibration?
if so, how can i get back the standard setting of idling speed? i got no tachometer..
Turn your Pilot air screw clockwise until it stops.
mark it, then turn it counter clockwise to the number of turns i mentioned in my previous posts.
after you set the pilot air screw, adjust the idle to something you think is ok.
a good way to know is if the headlight stops blinking then its good.