• If your have CLUB EVENTS/RIDE & would like to announce it here,
    Message traxxas-modifier about it :-)

Uma 62mm Bore Squish Band / Shaving

red sniper

New Member
Hi guys

just want to share this info

UMA Racing 62mm bore kit
- Piston top surface to block top surface clearance (no base gasket installed) = 0.53mm
- base gasket thickness = 0.5mm
- head gasket thickness =0.3mm



Using a digital meter
View attachment 24380



Piston top to block surface clearance without base gasket installed
View attachment 24381


After squishband/shaving, this is the new piston top to block top clearance
View attachment 24382

Hope that helps :D
nice mods paps... one thing i notice about the engine, the engine you are using was different with the engine of the sniper classic or mx, just wann know about your engine brand... tia more mods:thumbsup:
 

Takumi13

New Member
I'm using vixion kit and yy pang cam 5.8,is it safe to remove the base gasket and just use threebond gasketmaker?i'm afraid to shave the block.
 

KohenSanzo

New Member
bump for this topic sirs.
what i did to mine:
-vixion 150 kit
-base gasket removal (0.8mm thickness)
-gasketmaker used in place of base gasket.
-stock cyl head
no other adjustments made***

results:
better acceleration
BUT
backfiring, due to retarded cam timing via the chains.
during light engine braking or throttle release while in gear, flames comes out of the exhaust and backfires violently.

went back to the garage, i inspected the timing and at first you wouldnt notice the retarded timing of the cams,
but looking closely, may slight retard nga tlga! :'C saaaadd ako. huhu xD
i think i can correct it via the crankshaft side sprocket, but too lazy to do that as of now.

ano kaya ang other methods in addressing this problems mga sirs?
aside from (not sure yet) adjusting the crankshaft sprocket for the cam chain,
 

KohenSanzo

New Member
by the way, i tuned the carb and did the re-jetting process. its all good, and finely tuned. its just the retarded cam timing that's giving me headaches! haha more power to us all!
tia comrades!
 

Takumi13

New Member
bump for this topic sirs.
what i did to mine:
-vixion 150 kit
-base gasket removal (0.8mm thickness)
-gasketmaker used in place of base gasket.
-stock cyl head
no other adjustments made***

results:
better acceleration
BUT
backfiring, due to retarded cam timing via the chains.
during light engine braking or throttle release while in gear, flames comes out of the exhaust and backfires violently.

went back to the garage, i inspected the timing and at first you wouldnt notice the retarded timing of the cams,
but looking closely, may slight retard nga tlga! :'C saaaadd ako. huhu xD
i think i can correct it via the crankshaft side sprocket, but too lazy to do that as of now.

ano kaya ang other methods in addressing this problems mga sirs?
aside from (not sure yet) adjusting the crankshaft sprocket for the cam chain,
UP!
 
Top