• If your have CLUB EVENTS/RIDE & would like to announce it here,
    Message traxxas-modifier about it :-)

Uma 62mm Bore Squish Band / Shaving

Sniper 03

Veteran
bump for this topic sirs.
what i did to mine:
-vixion 150 kit
-base gasket removal (0.8mm thickness)
-gasketmaker used in place of base gasket.
-stock cyl head
no other adjustments made***

results:
better acceleration
BUT
backfiring, due to retarded cam timing via the chains.
during light engine braking or throttle release while in gear, flames comes out of the exhaust and backfires violently.

went back to the garage, i inspected the timing and at first you wouldnt notice the retarded timing of the cams,
but looking closely, may slight retard nga tlga! :'C saaaadd ako. huhu xD
i think i can correct it via the crankshaft side sprocket, but too lazy to do that as of now.

ano kaya ang other methods in addressing this problems mga sirs?
aside from (not sure yet) adjusting the crankshaft sprocket for the cam chain,

Sir i have same problem experience on our mc. I also shave off my block ng 1mm same observation on your bike timing chaine is noisy what we gona do is to use the manual adjuster to solve this problem like sir traxxas said.. But may carb is also noisy than my pipe. Its nakakainis becoz its on a front so i heard the carb than my pipe but the tune of my carb is fine. Im using oko 28mm carb w/o air filter...
 

neilryu04

Super Veteran
Sir i have same problem experience on our mc. I also shave off my block ng 1mm same observation on your bike timing chaine is noisy what we gona do is to use the manual adjuster to solve this problem like sir traxxas said.. But may carb is also noisy than my pipe. Its nakakainis becoz its on a front so i heard the carb than my pipe but the tune of my carb is fine. Im using oko 28mm carb w/o air filter...
What camshaft are using?
 

maky

Member
Bro. Can you teach me how to measure the valve to the piston for the valve pocketing? Stage 2 cam.
 
Top