• If your have CLUB EVENTS/RIDE & would like to announce it here,
    Message traxxas-modifier about it :-)

[TIPS] Optimum Air Fuel settings for your T135

rooster

Super Veteran
if i'm not mistaken a piggy bag is a device use to manipulate your ROM that controls the fuel injection, ignition timing etc etc...
it supposed to improve your performance...
but its way way expensive..
 

dchi

New Member
Ok. Thanks. I'll probably not do that then. I could have bought a CBR 150 if I needed more performance or a big bike for not too much more. I needed something pratical to go thru heavy traffic and make quick trips to the store and it does fine for that. I do like the fact that it needs not warm up. start it and go. The nouvo,wave and CBR150 all needed a few minutes to warm up.
 

rooster

Super Veteran
ya thats right goff..
no matter what kinda engine you got..it still got oil inside of it..n the oil will sink at the bottom overnight..
i think the purpose of getting it warmed up is..
so that the engine is fully circulated with enough lube before we hit the road and abuse it hehehe..:D
 

traxxas-modifier

Super LOLO
Staff member
reason for warm up is to prepare the engine to its normal or abuse use.

any material when its cold it contracts (smaller).
when its heated it expands (larger).

when your engine is still cold..
the cylinder is tight (small diamter) and when you REV IT HARD
when its still cold, it will wear your piston ring because
its tight..

when the engine is warm, the cylinder is now warm
and cylinder now expand to normal state
the piston ring just fits perfectly with the cylinder
so if you rev it hard and abuse it... its still ok..

me i warmed up my bike until the engine oil filter cover is warm.
regardless of how many minutes it will take.


yamaha said:
i'll try it..2-1/4 open turns from close ryt traxxas??
try 1 3/4 then test
2 then test
2 1/4 then test
and see what is best for you.
 

kamalez

Super Veteran
Warm the engine for 5-10Min before a wild ride. That ensure that all the wear + tear parts are coated with lub before contact with other parts.
Have not tried the setting on air screw, will do when time have.
Check the lub oil filter to be worm, that’s a tip to check. Probably I need to use my infrared digital thermometer for RC!!!!!!!!
 

yamaha

New Member
adjustment

ei it worx.. tnx traxxas. 2-1/4 turns.. b4 my 3rd gear was 105kmh.. now 110kmh. redline!! atlis a bit fast.. :lol: i dont know yet 4th gear.. coz the street is not enough. so many cars.. b4 my 4th gear was 130khm. maybe now 135 or 140kmh. and its not sound like R1. my brother has R1 b4 its not the same sound. no matter what happens it will not defenitely the same.. coz its only 1 cylinder. R1 is 4cylinder.thats y R1 sound's nice.. only the idle RPM goes high a lil.. i just adjust the idle screw, then back to normal.. tnx traxxas..
 

extremeT135

New Member
I've just adjust 2-1/4 turns yesterday. Actually, I dont feel so much different yet. I dont try the max speed of 3rd & 4th gear also. But I think the idle rpm will increase for sure. According to the my local dealer & service manual, the idle rpm should be 1300 - 1500rpm. Is this ideal state for my bike? What if it increase?
And the engine doesnt sound like R1, may be I need to add a few more pistons :D
 
actually 1 3/4 is the best. the std rpm for cars or bike the most is 700-900RPM. and the idling setting is for the air intake. correct me if im wrong.. :roll:
 

CarroTT

Super Veteran
CrescentScythe_86 said:
actually 1 3/4 is the best. the std rpm for cars or bike the most is 700-900RPM. and the idling setting is for the air intake. correct me if im wrong.. :roll:
where got idle so low wan :lol:
at least 1000 rpm lar

u tot the bike is a big v twin meh
like vulcan 1600 idles about 700 rpm oni
 

charge

Veteran
Hi guys, as far as i know, the 'pilot air screw' might be the fuel to inject into our carb at while we open throttle big.

When opening / closing the throttle on our right handle bar, we are actually controlling the air intake into the carb, instead of petrol.

How a Carb works:
http://auto.howstuffworks.com/question377.htm

Carb video: how it works
http://static.howstuffworks.com/mpeg/chainsaw3.mpg


quote from wikipedia:
"The carburetor works on Bernoulli's principle: the faster air moves, the lower its pressure. The throttle (accelerator) linkage does not directly control the flow of liquid fuel. Instead, it actuates carburettor mechanisms which meter the flow of air being sucked into the engine. The speed of this flow, and therefore its pressure, determines the amount of fuel drawn into the airstream."

The idle screw actually determines our petrol richness during light throttle and no throttle, while 'pilot-air-screw' determines our petrol richness during half - full throttle.
 

bloh

New Member
hi Traxx, I have tried 2 1/4 turn....I can feel abit power now, normally i go around 70-80kmh, after tune it, easily goes up to 90 to 100kmh.....wow.....and the sounds a bit differ......ahha......definitely not R1 Sound......its LC sound...kekek. Its a good tune.....will try some others tune.....and I can feel the 3rd gear can drag further.....better than the original tune.....which I like it....
 

kamalez

Super Veteran
It would go 0-100km faster then the stock coil, if you change the racing CDI as well then it will more faster.
I have not tried with the racing CDI,so can't give much review!!!!!!
I thick you are new in the forum, so take your time to flip around
 
Top