i suggested,just port and polish the exhaust part,leave the intake(oil in).i'm forgot about cam...how to define lift.easily said is uma or CMS is lift more 5.8 degree compared to stock cam.value of stock cam compared with UMA cam yields 5.8 lift difference.e.g:at 180 degree the stock cam displaced 3mm and at 180 degree uma cam displaced(valve opening distance) 8.8mm,thus UMA LIFT 5.8 more than the stock at 180 degree.low cam is the cam displacement is same as the stock cam,BUT the duration of the opening is longer than the stock cam,thus usually low cam promises top end rather than acceleration.the opening allowing the increasing in time for fuel to flow in to combustion chamber,give the system an advancing timing.
haha,i stop here.
port polish is a good practise after a few month of road riding.
if u want a low maintenance bike,use a low cam cause the lift same as stock only the opening duration of valve is longer.
e.g:stock cam can get 140 kmh,low cam can get 150-160 kmh.(our bike meter..haha) BUT taking a time bfr the system switched from idle/stock to advancing.
high cam is powerful at both acc and top end,but u need to recheck the clearence between maximum valve displacement and top piston displacement known as TDC(top dead centre).miscalculate of this cause a phenomena called knocking?the piston head knocked by the valve.if too high compression also can caused leaking.all COST u much.
sometime even the cam is good,but when applied to the machine,the output is fail cause the combination is not synchronised.haha,too many thing to up here.
haha,i stop here.